More wiring on Camford Junction

After a few club-nights the main line wiring on one board is finally complete. The amount of wiring would have been a lot less if we had gone for DCC, but I am the only member of the group with DCC fitted stock, and it is not of the right era for the layout, so I lost that battle.

The relays, controlled by Merg CBus modules, switch the various track sections between the 4 main line controllers. There are only 3 points on the main line on this board, controlled by the black Merg CBus CANSERVO8 module.

The wiring along the edge of the layout consists the 4 controller feeds, 12V and 5V power supplies and the CBus pair. The wiring down the other side of the raised section is the feed from the relays to the track sections. The expanse of virgin white board, where the documentation is laying, will be home to the MPD, and will be covered with servos and more Merg CBus modules eventually.

 Meanwhile, the second board has had most of its hardware fitted and will be ready for wiring up to commence while track laying for the MPD area can start on the first board. This board also has just 3 points on the main lines. The tie-bars have been fitted and the servos will be fitted next week, hopefully. Note, the elevated secondary main line diverges from the main, main line on this board, running along what will be filled, brick arches.